Machine vision

How a vision system is designed

A reliable inspection depends on more than the software. This page walks through the five things Deepview works out for every application, and the partners we use for each.

Optics

The lens decides what the camera can see. We start from the smallest defect you need to find and work back to the lens.

  • Field of view: how much of the part must be in the picture, with room for part position to vary.
  • Working distance: how far the lens can sit from the part on your line.
  • Resolution: enough pixels across the smallest defect for the network to learn it.
  • Depth of field: how much of a tall or tilted part stays in focus.
  • Lens type: fixed focal length for most jobs, telecentric where measurements must not change with distance.

Optics partners

  • Edmund OpticsImaging lenses and filters
  • ComputarMachine vision lenses

GigE cameras

The camera is matched to the lens, the line speed and the number of views. GigE Vision cameras run on standard Ethernet cable over long distances.

  • Sensor resolution: chosen with the lens so the defect covers enough pixels.
  • Shutter and frame rate: global shutter and short exposure for moving parts.
  • Mono or colour: monochrome for surface and shape defects, colour where colour is the defect.
  • Triggering: a sensor or PLC signal takes the picture at the same part position every cycle.
  • Number of cameras: one view per face that needs inspecting, all read by one vision processor.

Camera partners

  • Allied VisionIndustrial GigE and USB cameras
  • JAIIndustrial GigE cameras

Lighting

Lighting makes the defect visible. The same scratch can vanish or stand out depending on the angle and colour of the light.

  • Geometry: ring, bar, dome or backlight, picked for the surface and the defect.
  • Angle: low-angle light for scratches and edges, diffuse light for shiny parts.
  • Wavelength: white, red, blue or infrared to raise contrast on the material.
  • Strobing: short, bright pulses that freeze motion and outshine plant lighting.
  • Shielding: covers that keep changing daylight and overhead lights out of the picture.

Lighting partners

  • Spectrum IlluminationMachine vision lighting
  • Smart Vision LightsMachine vision lighting

Work cell build

The optics, cameras and lights are built into a cell that holds the part the same way every time and talks to your line.

  • Part presentation: fixtures, conveyors or robots that put the part in the same place each cycle.
  • Mounting: rigid camera and light mounts that stay aligned through vibration and cleaning.
  • Controls: a control panel with the vision processor, power and PLC connection.
  • Line integration: pass and fail signals, reject handling and an operator screen.
  • Install and support: commissioning on site and support after the cell is running.

Work cell partners

  • Industrial ControlAutomation and controls
  • ThorpWork cell build

Feasibility

Before a cell is built, we prove the inspection on your own parts.

  • Send parts: good parts and examples of each defect you need to catch.
  • Imaging trials: we try lens, camera and lighting combinations until the defects show clearly.
  • Train a network: the Deepview software is trained on labelled images of your parts.
  • Results: you see the detections and the recommended hardware.
  • Decision: you know the inspection works before committing to a build.

Start a feasibility study

Schedule a call

Tell us about the part and the defect. We will talk through optics, cameras, lighting and the cell.